Few months ago message Suspension Fault Normal Height Only came up to dashboard. I bought full kit from you recently and replaced all the components, but somehow the fault is still displayed on the dashboard every time after engine started (about 30 seconds after start). Today I tryed to lift the truck and display showed Suspension raising slowly. 14. Reaction score. 0. Location. 1511 Willow Greene Drive. samnt650 said: I understand the height sensor voltage read out are reference points. My questions: Between Access, Normal, Off-Road and Super Extended. Visit Autofthings to review headlight uv protection if you concern. Then in the middle of driving on a flat, dirt road (nothing challenging or abnormal) I heard a large hiss/phshhhhhh for 2-3 seconds. I was damn sure I blew out a tire and badly - but I didn't. Afterwards I was getting an Amber Suspension fault light and a "Suspension Fault - Normal Height Only" message. Step 1: Remove the old height sensor. Disconnect the battery to avoid any electrical shorts. Locate the height sensor. It is usually located in the rear of the vehicle. Remove the sensor from the bracket by removing the bolts that hold it in place. Disconnect the wiring harness from the sensor. I got the dreaded yellow light and Suspension fault - normal height only warning this morning on my way to the shops. Asked my daughter to check if the brake lights were working when I parked which they were. After shopping I turned the key and let it do the diagnosis before starting the engine. All was fine. I have a 2012 LR4 and here are some of the facts. Fault says Normal Height Available only (GAP IID Tool) - Fault Code is C1A34-01 (AF) Rear Right Corner Valve - General Failure Information - General Electrical Failure. I occasionally get an. C1A36-01 (2E) Exhaust Valve - General electrical Failure. Not sure if these are related. Community site dedicated to Discovery 3, 4 LR3 and LR4 Owners and Enthusiasts. suspension fault - normal height only message. Message go away if I restarted car Suspension alert normal height only idiot light. 2016 LR4 HSE. Compressor has been slow for a while and off-roading may have finished it off. Rides and drives fine. 4x4 screen shows nothing abnormal re: wheel height but when parked right front is downabout 0.25 inches. On road taking daughter to school and leaving it with her when we get there. So I changed out my rear solenoid valve block today on my 2007 LR3 V6. I found that the new Voss fittings came installed on the new block. The change-out went smooth enough, but my issue isn't repaired. I keep getting a suspension fault-Normal height only alarm come in, and it keeps me from changing the suspension height up or down. To put less stress on the compressor, the car was jacked up above standard height back and then front - if out in the bush, you can do 1 corner at a time if needed, using the OE jack. Then using my IID Tool BT and the app on my phone, I had the car started, then went into Service/Test -> RLM Suspension -> Test Valves. WodnzE1.